AUDIOPIPE APEL-1500.1

EXCEPTIONAL PERFORMANCE: Our APEL-1500.1 is a highly efficient device that significantly reduces power loss. It stores excess energy until needed, preventing its conversion into heat. Its compact design, smaller heat sink, and simplified circuitry contribute to its reduced size, weight, and energy waste.

MAXIMUM OUTPUT POWER: Class D topology is an amplifier configuration that achieves high efficiency while maintaining a compact form factor and high output power. With up to 1500 watts of exceptional performance, this particular amplifier is designed to drive subwoofers and subwoofer systems, ensuring the best possible sound quality for car audio systems.

FREQUENCY RESPONSE: 18 Hz - 180 kHz

CONTINUOUS OUTPUT POWER: RMS @ 4 Ohm (<1% DISTORTION): 500W RMS @ 2 Ohm (<1% DISTORTION): 900W RMS @ 1 Ohm (<1% DISTORTION): 1500W

SIGNAL-TO-NOISE RATIO: ≥80dB

INPUT LEVEL: 0.25 - 4V

1 OHM STABLE: This 1500W Class D MOSFET amplifier (APEL-1500.1) is designed to continuously drive 1-ohm loads without overheating. It is typically used to power subwoofers that require a higher power load to operate at their optimal level.

OVERLOAD PROTECTION: This amplifier is equipped with overload protection, ensuring a safe and reliable audio experience.

OVERHEAT PROTECTION: This amplifier features an advanced heat sink designed to provide reliable overheat protection.

OVERHEAT PROTECTION TEMPERATURE: 80 °C / 176 °F

SUBWOOFER VOLUME REMOTE CONTROL: This amplifier features a remote bass control knob, a clip LED, and a power on/off LED. Easily control your audio volume and monitor your amplifier's performance.

DOUBLE-SIDED PRINTED CIRCUIT BOARD DESIGN: This 1500W Class D Mosfet amplifier (APEL-1500.1) uses a double-sided printed circuit board (PCB) to improve electrical performance and component layout, resulting in more efficient signal flow and reduced interference.

BASS BOOST: 0-12 dB @ 40Hz-180kHz DIMENSIONS: 9" x 2.5" x 15.5" (W x H x D) 232 x 53 x 348 mm